Table of Contents
Advertisement
Remote controlling the recording/playback
Open the popup screen on the V-Mixer to remotely control the R-1000.
Track settings
Open the R-1000 patchbay and assign channels/tracks as shown below. In this scenario, we'll be patching inputs from the digital
snake units (connected to REAC C and D) to record directly from them. We'll be patching the R-1000 track outputs to the V-Mixer
(REAC A and B).
• Recording Assign Inputs (1-16) of REAC C port to recording tracks 1 through 16.
Assign input (1-16) of REAC D port to recording tracks 17 through 32.
• Playback
Assign playback tracks 1-16 to outputs 1 through 16 of REAC A port.
Assign playback tracks 17-32 to outputs 1 through 16 of REAC B port
* It is easy to assign these channels using the auto map function. Use [F-7] of the V-Mixer's function button to call up the auto map function.
fig.patchbay-case2.eps
Start recording/playback on the R-1000
Arm/Select tracks and set virtual preamp via remote control from the V-Mixer. Then start recording/playback.
fig.R1000-coontrol-popup1.eps
During playback, you can turn off the PLAY buttons of any playback tracks and allow the live performer to perform along with the other tracks.
Just make sure their microphones are patched to the corresponding inputs of the R-1000.
Use in Connection with the V-Mixer
9
Advertisement
Table of Contents
