Using The Gas Hob; Before First Use; Setting The Time Of Day - Baumatic OMBRA6SS Instruction Manual

Using the gas hob

Before first use

IMPORTANT: You should clean the hob surface (see
"Cleaning and maintenance" section).

Setting the time of day

Each time the power supply is cut off, the time displayed by the
hob clock must be reset.
o After initially powering the hob, the number 0.00 will appear on
the timer display (6) with a flashing decimal point.
o In this mode, the hob is in stand-by and can only be switched on
by pressing the ON / OFF button (1).
o After pressing the power button, the time can be set. If the time
is not set, the clock will continue to automatically count the time
that has passed from when it was connected to the mains power
supply.
o To set the time, press the timer button (5) and safety lock
button (2) simultaneously for at least three seconds.
o Once these buttons are pressed, the hour digit will start to flash.
You can then adjust the hour using the timer plus (4) and minus
(3) buttons. The variation will be continuous if the button is held
down.
o Press the timer button (5) again to confirm the hour and the
minute digit will start to flash.
o To program the minutes follow the same steps outlined above.
Press the timer button (5) to store the set time.
11