If any VPS port is in use, the VPS will display the following warning:
*** Now Line is used!! *** <WAIT>
The VPS will be in the Off-Line Mode when the following message is displayed.
** OFF LINE MODE **
7.2.2 On-line Set (ONLN)
The ONLN command is used to place the VPS in the Call Progressing Mode.
Type ONLN, then Press RETURN.
$ ONLN
** ON LINE MODE **
7.2.3 Set Password (PASS)
The PASS command is used to create, change and clear system passwords. Valid passwords are
created using up to 8 characters; any character except [\] can be used.
1.
Type PASS, then Press RETURN.
$
1: Administrator Password 2: System Reset/Clear Password :=
2.
To create a password or change an existing password, go to Step 3.
To clear a password, go to Step 4.
3.
To create a password or change an existing password:
a. Type [1] or [2].
Maximum 8 characters
NEW PASSWORD : =
Note
When you press [2] to change the System Reset/Clear password you should type the
current (OLD) password before entering a new one.
b. Type the password.
Verification: =
c. Type the password again for verification.
4.
To clear a password:
a. Type [1] or [2].
SYSTEM MAINTENANCE AND TROUBLESHOOTING
7.2 UTILITY COMMANDS
139