Pbx Requirements For Integration - Panasonic KX-TVS75 Installation Manual

The VPS must also have access to certain PBX features. For example, if the VPS takes a
message, one way it can notify the mailbox owner is by dialing the PBX's Message-Waiting-
Lamp-On code. Once new messages are retrieved, the VPS dials the Message-Waiting-Lamp-
Off code for that same mailbox owner.

3.1.4 PBX Requirements for Integration

The PBX must have certain capabilities and features to work with the VPS. (Although this
section includes tests to help you evaluate the PBX, it may be necessary to refer to the PBX's
documentation for detailed capability and feature descriptions.)
Single Line (Tip/Ring) Port Circuits
The VPS can only be connected to a PBX that supports SLT sets. Some PBXs need an OPX
card to provide this connection. However, some OPX cards do not provide all the capabilities
listed in this section.
Following are the minimum current and voltages that the PBX must supply:
Minimum Loop Current
Minimum Line Voltage
Minimum Ringing Voltage
Station to Station DTMF Signaling
For system users to access VPS services and features, they must be able to send DTMF tones
from their telephones to the VPS port. As a general rule, SLT sets can perform station-to-
station DTMF signaling; however, many proprietary telephones cannot. Some PBXs need to
be programmed to make proprietary sets use DTMF signaling.
If the PBX does not provide station-to-station DTMF signaling, VPS services and features
will be limited.
TEST:Call an SLT extension from the telephone in question. When the call
is answered, see if the person receiving the call hears DTMF tones when
numbers are dialed.
Message Waiting Notification from an SLT
The PBX extensions should light a lamp or receive stutter dial tone when the Message-Waiting-
Lamp-On code is dialed by the VPS. The VPS functions best when the extension number of
the voice mailbox owner follows the Light-On or Light-Off code. On some PBXs, however, the
INTEGRATING THE VPS WITH PANASONIC KX-T PHONE SYSTEMS
Table 14
20 mA
7 V DC
40 V AC
3.1 GUIDELINES FOR INTEGRATION
55