Running The Setup Wizard At Any Time - Leica mojo 3D User Manual

Leica mojo3D, Running the mojo3D for the First Time
3.10
General informa-
tion
Running the setup
wizard, step-by-
step


Running the Setup Wizard at any Time

The initial setup wizard can be run again at any time after the initial setup.
The wizard guides you through the whole system setup: System Setup, Vehicle Setup,
Attached Device Selection, NMEA Configuration. Alternatively you are able to setup
specific sections separately via the appropriate setup button.
To run the Setup Wizard, carry out the following steps:
1. On the main navigation screen, tap the Settings button.
2. On the flyout menu, tap the setup wizard button.
3. On the attached device selection screen, tap the icon that
describes your setup, for example mojo3D button.
4. Tap to continue through the setup wizard. Make any changes that are
required.

For specific information on the different settings refer to "3.3 Initial Setup
Wizard".
All changes are automatically saved as they are made.
60