Installation; Preparations - Husqvarna AUTOMOWER Operator's Manual

3. Installation

This chapter describes how you install Husqvarna
Automower . Before starting the installation read the
®
previous chapter 2. Presentation.
Read the whole of this chapter too before starting the
installation. How the installation is made also affects how
well Automower will work. It is therefore important to plan
®
the installation carefully.
Planning is simplified if you make a sketch of the working
area, including all obstacles. This makes it easier to see
the ideal positions for the charging station, boundary wire
and guide wire, if used. Draw on the sketch how the
boundary wire and the guide wire, if used, should be
routed.
Carry out the installation in the following steps:

3.1 Preparations.

3.2 Installation of the charging station.
3.3 Charging the battery.
3.4 Installation of the boundary wire.
3.5 Connecting the boundary wire.
3.6 Checking the installation.
3.7 Linking Automower® to the charging station.
3.8 Installation of the guide wire.
To carry out a complete start-up of Automower
ing station must be in position and connected, the bound-
ary wire connected, and the mower connected to the
charging station. If you would like to start the mower with-
out having completed the full boundary installation, you
can connect a temporary short loop around the mower.
3.1 Preparations
1. If the lawn in the proposed working area is taller
than 4", mow it using a normal lawn mower. Then
collect the clippings.
2. Read carefully through all the steps before the
installation.
3. Check that all parts for the installation are
included:
The numbers in brackets refer to the detail
diagram 2.1 Automower®, what's what? on
page 11.
• Operator's Manual (26)
• Automower ®
• Charging station (15)
• Loop wire for the boundary wire and guide wire (18)
3. INSTALLATION
the charg-
®
English - 17