Trouble Shooting; Fault Messages - Husqvarna AUTOMOWER Operator's Manual

9. Trouble shooting

9.1 Fault messages

A number of fault messages are listed below that can be shown on the Husqvarna Automower
same fault occurs frequently: contact your dealer.
Fault message
Left wheel motor
blocked
Right wheel motor
blocked
Blade disc blocked
No loop signal
Trapped
9. TROUBLE SHOOTING
Cause
Grass or other object has wrapped
around the drive wheel.
Grass or other object has wrapped
around the drive wheel.
Grass or other object has wrapped
around the blade disc.
The transformer is not connected to
the mains supply or its miniature
circuit-breaker has tripped.
The boundary wire is not connected
to the charging station.
Boundary wire broken.
The connection between Automower
and the charging station has been
lost.
This may be due to the boundary wire
being routed in the wrong direction
around an island, which blanks out
the signal.
If this occurs in isolated areas it may
be due to interference from metallic
objects (perimeter fence,
reinforcement bar) or buried cables in
the vicinity.
Automower ® has got caught in
something.
Action
Check the drive wheel and remove
the grass or other object.
Check the drive wheel and remove
the grass or other object.
Check the blade disc and remove the
grass or other object.
Check the wall socket connection and
whether the miniature circuit-breaker
has tripped.
Reset the miniature circuit-breaker by
removing the transformer's power
cord from the wall socket, wait
10 seconds and then reconnect the
power cord in the wall socket again.
Check the signal given by the LED in
the charging station. If it flashes, it
may be that the boundary wire is not
connected. Check that the boundary
wire's connectors are properly
connected to the charging station.
Check the signal given by the LED in
the charging station. If it flashes the
loop may be damaged. Repair the
break on the wire using the original
coupler.
® Place Automower ®
station and change the PIN-code via
Settings - Security - PIN code
(shortcut 4-1-1). You can use the
same PIN code as earlier.
Check that the boundary wire has
been routed correctly.
Try moving the boundary wire.
Free Automower ® and rectify the
reason for it getting trapped.
. If the
®
in the charging
English - 71