Husqvarna AUTOMOWER Operator's Manual page 57

To find out the distance from the charging station
to a remote area:
• State a distance that easily exceeds the true
distance. The maximum distance that can be
stated is 500 meters (1600 ft). State the value
100 % for Proportion for the area to which the
distance is to be measured and 0 % for the other
areas. Place Automower
and select Test OUT (3-2-5). The mower will
now leave the charging station in keeping with
the stated direction. Stop the mower after the
required distance, open the solar cell panel and
read off the distance stated in metres on the
mower's display. Enter the number of metres
shown in Distance for the area in question.
Reset the Proportion values when testing is
finished.
Installation shape (3-3)
Automower can be set according to three installation
®
shapes: Open, Normal and Complex.
This setting affects how Automower
working area when it mows. Above all it influences
the turning angles and how often the mower changes
direction. The Open setting optimizes the pattern of
movement for an open garden. If the garden contains
a lot of small areas linked with passages a better
function will be obtained with the Complex setting.
Select:
• Open (3-3-1)
for an open lawn area with few obstacles and no
passages.
when steep slopes give an uneven mowing result.
• Normal (3-3-2)
for an average number of obstacles and/or
passages.
• Complex (3-3-3)
for a large lawn area and large number of
obstacles and/or passages.
Advanced (3-4)
• Drive past wire (3-4-2)
The front of Automower
boundary wire by a specific distance before the
mower turns. The default distance is 27 cm (11"),
but this can be changed if required. The
minimum value is 15 cm (6") and the maximum
value is 50 cm (20").
To adjust the distance: Move the cursor to Drive
past wire and press YES. Now specify the
number of centimeters you want Automower
pass the boundary wire.
6. MENU FUNCTIONS
® in the charging station
covers a
®
® always passes the
® to
Exit angles
Follow loop
Installation shape
Advanced
3-3
Exit angles
Follow loop
Installation shape
Advanced
3-4
Open
Normal
Complex
3-3-
Check loop
Drive past wire
3-4-2
English - 57