Adam Equipment HIGHLAND SERIES User Manual page 18

P3 AUT
Press the [Mode] key to change the setting. Press [Tare] to confirm and move
to the next parameter.
7) Setting the baud rate. This is the transmission speed for communication with
printers and computers. The selected rate must match that of the other
device for communications to work.
The following settings are available:
b
b 1200
b 2400
b 4800
b 9600
Press the [Mode] key to change the setting. Press [Tare] to confirm and move
to the next parameter.
8) Parity settings. Parity is a communications check. There are 3 settings that the
Highland can work with as follows:
8 n 1
7 E 1
7 0 1
Press the [Mode] key to change the setting. Press [Tare] to confirm and move
to the next parameter.
16 |
P a g e
The weighing results will be sent to the
communication port automatically
whenever a stable reading is present.
The balance has to return to zero
before another reading is sent via the
interface.
600
8 data bits, no parity
7 data bits, even parity
7 data bits, odd parity
Automatic accumulation when
stable
© Adam Equipment Company 2011