Menvier Security TS2500 Operator's Manual page 37

Fault Finding
Cannot Set
Messages
Display Messages
Another user is accessing the alarm system.
You cannot use your keypad until this message
has cleared.
The TS2500 has an high security feature which
can be applied to any ward. When the ward is
unset the remote keypads display "HI SECURE
UNSET" and the high security timer is started.
Every time a detection device is triggered
within the selected ward the timer is reset.
However, if no detection devices within the
selected ward are triggered, the timer will
eventually expire. When the timer expires the
ward is automatically set and the message on
the keypads is cleared.
This message is displayed whenever a keypad
is locked out because there has been too
many invalid code entries. This message will
clear and the keypad will unlock itself after 5
minutes.
These messages occur when the system is
unable to set your selected wards.
Cannot set due to a tamper fault on auxiliary
circuit 1 or 2. Clear the fault and if still
displayed contact your alarm company for
further advice.
Cannot set due to a tamper fault on the
external sounder. Clear the fault and if still
displayed contact your alarm company for
further advice.
Cannot set due to a fault from one or more
system components. The display will indicate
the faulty device. Clear the fault and if still
displayed contact your alarm company for
further advice.
Cannot set due to a fault from one or more
circuits. The display will indicate the faulty
circuits. Clear the fault and if still displayed
contact your alarm company for further
advice.
Cannot set due to a tamper fault on the
control panel. Clear the fault and if still
displayed contact your alarm company for
further advice.
35