Menvier Security TS2500 Operator's Manual page 23

Operation
Remote Reset
Resetting after an Alarm
Full alarms generated in a ward that is
configured as remote reset can be reset
by the engineer or the user via the
exchange of unique passcodes.
From step 5 of "Unsetting after an Alarm".
1. At the designated remote keypad enter
your passcode.
2. Every minute the display will inform you
of the action to take (normally "CALL
A.R.C FOR REM. RESET CODE", although
your alarm company can change this
to more relevant information).
3. Enter your passcode followed by the [
key.
4. The display will advise you of the
number to quote to your alarm
receiving centre.
5. Contact your alarm receiving centre.
6. You will be asked to report the
circumstances of the alarm. If the
alarm receiving centre decides you do
not require an engineer, a 4 digit
remote reset code will be given to you.
7. Enter the 4 digit remote reset code
followed by the [ key and the system
will return to its normal condition.
21