Quicksilver Side; Remote Control Components - Mercury 50 User Manual

REMOTE CONTROL COMPONENTS

Neutral Lock Bar prevents accidental
shift and throttleengagement. Bar must be
squeezed before control handle can be
moved, from NEUTRAL.
-
C o n t r o l Handle c o n t r o l s forward,
reverse motiori and engine speed.
turns engine
O N and OFF actuates electric starter
motor actuaies carburetor e n r ~ c h e n e r
and sounds alarm horn momentarily t o test
warning circu ts
Lanyard Stsp S w ~ t c h Refer to page 1
for explanation The lanyard cord/clip,
when used wlth the lanyard stop switch
MUST BE connected to boat driver Should
driver be unable t o reach steering wheel or
remote contrcl, the lanyard cord/cllp will
be pulled from lanyard stop swrtch and the
engine w ~ l l st ut OFF This lanyard stop
engine shut-otf
IMPORTANT: The Lanyard Stop Switch
can be repositioned to RUN with orwithout
lanyard cordlclip so that engine can be
restarted.
OPERATION
MODELS WITH REMOTE CONTROL
WARNING HORN OPERATION
oil level in the oil injection system.
The warning horn is located inside of side
mount remote control. If boat is equipped
with a panel orconsole remotecontrol, the
warning horn incorporated behind the
key switch in the key switch wiring har-
ness.
Each timethe key switch isturned form the
"OFF" position t o the "ON" position the
warnina horn will sound momentarily. This
indicates thatthe warning system will func-
Engine can I,e restarted with or without
lanyard cord/cl$p Installed by simply push-
ing switch u p to run position If necessary
push switch d o m w ~ t h key to reinstall clip
6
FA S T I D L E LEVER engine
throttle a d v a r t x m e n t , without shifting
gears, to assist engine starting.
THROTTLE FRIC7 I O N Adjustmerit
Knob
that boat s p e w can be set and driver does
not have to hol I handle Turn knob clock-
wise to increas? frictio? D O N O T thread
knob all the w a ] out
8
-
Tachometer Receptacle Wiring har-
ness connector for optional tachometer.
Power Trim)
pressing u p switch t r ~ m outboard i n
(down) b y pres dng d o # n o n swltch
Warning H o r n Located i n Remote
-
Control. Refer to "Operation" "Warning
Horn Operatior" following.
the "OFF" position to the "ON" position or
continually sounds, see an Authorized
Dealer. DO NOT operate the engine.
The warning system gives the following
indications:
MOMENTARY BEEP (when key switch is
turned on) -circuit test of warning system.
.
level