KYMCO People GT 300i Service Manual page 183

14. STEERING HANDLEBAR/FRONT WHEEL/FRONT
BRAKE/FRONT SHOCK ABSORBER/FRONT FORK
BRAKE CALIPER
REMOVAL
First drain the brake fluid from the hydraulic
brake system.
Remove the brake fluid tube bolt.
Remove the two bolts attaching the brake
caliper.
Remove the brake caliper.
INSTALLATION
Install the two brake pads.
Install the two brake pad dowel pin and
tighten them.
When installing the brake caliper, be
sure to position the brake disk between
the two brake pads.
Install the brake caliper to the shock absorber
and tighten the two bolts.
Torque: 35 N-m
Connect the brake fluid tube with the
attaching bolt and two sealing washers to the
brake caliper and tighten the fluid tube bolt.
Torque: 35 N-m
Fill the brake reservoir with the specified
brake fluid and bleed air from the brake
system. ( 14-10)
When installing the brake fluid tube, be
sure to install the two sealing washers.
14-11
Washers Brake Fluid Tube
People GT 300i
Bolts