KYMCO People GT 300i Service Manual page 179

14. STEERING HANDLEBAR/FRONT WHEEL/FRONT
BRAKE/FRONT SHOCK ABSORBER/FRONT FORK
Pack all bearing cavities with grease.
Drive in the left bearing.
Install the distance collar.
Drive in the right bearing.
• Do not allow the bearings to tilt while
driving them in.
• Drive in the bearing squarely with the
sealed end facing out.
Special Tools
Oil seal & Bearing Driver
INSTALLATION
Insert the axle and tighten the axle nut.
When installing the front wheel, take
the brake disk among the two brake
pads.
Torque: 65 N-m
14-7
E014
Driver Handle
Axle
People GT 300i
Outer Driver