KYMCO People GT 300i Service Manual page 106

10. A.C. GENERATOR/STARTER CLUTCH
INSTALLATION
Install oil pump and tighten two bolts.
Make sure that the pump shaft rotates freely.
The arrow of oil pump is upside.
Install cam chain.
Install the pump drive chain and driven gear,
then set the clip securely on the pump shaft.
Install the oil separator cover properly.
Fit the tab of the separator cover into the
slit in the separator.
10-7
Arrow Mark Bolts
Oil pump
Oil Pump Drive chain
Oil Pump Driven Gear
Oil Separator Cover
People GT 300i
Cam Chain
Cam Chain
Clip
Bolts