Stator Installation; Right Crankcase Cover Installation - KYMCO People GT 300i Service Manual

10. A.C. GENERATOR/STARTER CLUTCH

STATOR INSTALLATION

Install the A.C. generator stator on the right
crankcase cover and secure it with the three
bolts.
Install the pulsar coil on the right crankcase
cover and secure it with the two screws.
Install the wire grommet in the groove in the
right crankcase cover securely.
Be sure to route the stator wire under the
pulsar coil.
RIGHT CRANKCASE COVER
INSTALLATION
Install the two dowel pins and a new gasket.
Install the right crankcase cover over the
crankcase, aligning the water pump shaft
groove with the oil pump shaft.
Tighten 12 bolts attaching to right crankcase
cover.
Connect the water hoses to the right
crankcase cover and water pump cover.
Add the recommended engine oil.
Fill the cooling system with the specified
coolant.
• Be sure to bleed air from the water
hose after filling the coolant.
10-9
Screws
Pulsar Coil A.C. Generator Stator
Dowel Pins
Right Crankcase Cover
Water Pump Shaft
People GT 300i
Gasket
Water Hose