Available Dsp Modes According To The Speaker Arrangement - JVC RX-778VBK Instruction Manual

Available DSP Modes According to the Speaker Arrangement

Available DSP modes will vary depending on how many speakers are used with this receiver.
Make sure that you have set the speaker information correctly (see page 14).
Speaker arrangements
Front TV
speaker
Front TV
speaker
Center speaker
TV
Front
speaker
Rear
speaker
TV
Front
speaker
Center speaker
Rear
speaker
22
Each time you press DSP MODE on the front panel or SURROUND MODE on
the remote control, the DSP modes change as follows:
Front
speaker
• 3D THEATER
• LIVE CLUB
• DANCE CLUB
• HALL
• PAVILION
• 3D ACTION (or 3D DIGITAL)
• DSP OFF (DSP mode is canceled)
Each time you press DSP MODE on the front panel or SURROUND MODE on
Front
the remote control, the DSP modes change as follows:
speaker
By pressing DSP MODE:
• THEATER (or DIG THEATER)
• LIVE CLUB
• DANCE CLUB
• HALL
• PAVILION
• 3D ACTION (or 3D DIGITAL)
• DSP OFF (DSP mode is canceled)
Front
speaker
To activate the Surround
mode, press DOLBY
SURROUND button so that the
lamp on the button lights up.
Rear
speaker
Note on the center speaker sound when using the DAP modes:
Front
Sounds come out of the center speaker only if the following take place at
speaker
the same time:
• If "CENTER SPK" is set to "LARGE" or "SMALL."
• If the center channel signals come into this receiver ( C of the signal
indicators lights up — see page 10) while playing a multi-sound source
encoded with Dolby Digital.
Rear
In this case, you cannot adjust the center speaker output level.
speaker
Available DSP modes
By pressing SURROUND MODE:
• DOLBY SURROUND
(DOLBY PRO LOGIC, DOLBY
DIGITAL)
• THEATER (or DIG THEATER)
• LIVE CLUB
• DANCE CLUB
• HALL
• PAVILION
• 3D ACTION (or 3D DIGITAL)
• DSP OFF (DSP mode is canceled)
To activate the Surround
mode, you can also use the
SURROUND ON/OFF button.