Connecting Audio/Video Components - JVC RX-778VBK Instruction Manual

Connecting Audio/Video Components

You can connect the following audio/video components to this
receiver. Refer also to the manuals supplied with your components.
Audio Components
• Turntable
• CD player*
• Cassette deck
or MD recorder*
* You can connect these components using the methods described
in "Analog connections" (below) or in "Digital connections" (see
page 8).
Analog connections
Audio component connections
Use the cables with RCA pin plugs (not supplied).
Connect the white plug to the audio left jack, and the red plug to the
audio right jack.
CAUTION:
If you connect a sound-enhancing device such as a graphic equalizer
between the source components and this receiver, the sound output
through this receiver may be distorted.
Turntable
If an earth cable is provided for your
turntable, connect the cable to the
screw marked (H) on the rear panel.
Turntable
To audio output
Note:
Any turntables incorporating a small-output cartridge such as an MC
(moving-coil type) must be connected to this receiver through a
commercial head amplifier or step-up transformer. Direct connection
may result in insufficient volume.
CD player
CD player
To audio output
6
Video Components
• DVD player*
• TV
• DBS tuner*
• VCR
AUDIO
RIGHT LEFT
PHONO
CD
OUT
(REC)
TAPE
/MD
IN
(PLAY)
AUDIO
RIGHT LEFT
PHONO
CD
OUT
(REC)
TAPE
/MD
IN
(PLAY)
Cassette deck or MD recorder
Cassette deck
To audio input
RIGHT
MD recorder
To audio input
Note:
You can connect either a cassette deck or an MD recorder to the
TAPE/MD jacks. When connecting an MD recorder to the TAPE/MD
jacks, change the source name, which will be shown on the display
when selected as the source, to "MD." See page 12 for details.
If your audio components have a COMPU LINK-3 or TEXT
COMPU LINK terminal
• See also page 33 for detailed information about the connection and
the COMPU LINK-3 remote control system.
• See also page 34 for detailed information about the connection and
the TEXT COMPU LINK remote control system.
To audio output
AUDIO
LEFT
PHONO
CD
OUT
(REC)
TAPE
/MD
IN
(PLAY)
To audio output