Handlebar Switches - Qlink RD400 User Manual

Handlebar switches

① Light switch "
/ /OFF"
② "
Engine stop switch /
③ Start switch " "
" "
Light switch / /OFF
Set the switch to " " to turn on the low beam and the
taillight.
Set the switch to " " to turn on the high beam and the
taillight.
Set the switch to FF to turn off all the lights. O
USER'S MANUAL
Do not use the headlights with the engine turned off for
more than fifteen minutes.
the battery may discharge to the point that the starter
motor will not operate properly. If this should happen,
remove the battery and recharge it.
Engine stop switch "
Make sure that the engine stop switch is set to" "
before starting the engine. The engine stop switch
controls ignition and can be used at all times to stop the
engine, especially in an emergency. The ngine will not
"
start or run when the engine stop switch is set to "
17
"
/
e
"