Adjusting The Rear Brake Light Switch - Qlink RD400 User Manual

POTENTIAL HAZARD
Operating with improperly serviced or adjusted brakes.
WHAT CAN HAPPEN
You could lose braking ability, which could lead to an
accident.
HOW TO AVOID THE HAZARD
After servicing:
Make sure the brakes operate smoothly and that the
free play is correct.
Make sure the brakes do not drag.
Replacement of brake components requires professional
knowledge. These procedures should be performed by a
ATV dealer.
Replacement of brake components requires professional
knowledge. These procedures should be performed by a
dealer.
USER'S MANUAL

Adjusting the rear brake light switch

The rear brake light switch, which is activated by the
brake pedal and rear brake lever, is properly adjusted
when the brake light comes on just before braking takes
effect. If necessary, adjust the brake light switch as follows.
1. Remove panel A. (See page 102 for panel removal and
installation procedures).
2. Turn the adjusting nut while holding the rear brake
light switch in place. To make the brake light come
on earlier, turn the adjusting nut in direction a .
To make the brake light come on later, turn the
adjusting nut in direction b .
3. Install the panel.
131