Charging; Connecting The Load (E.g. Computer) - AEG Protect A. 1000 Operating Instructions Manual

EN
5.3

Charging

The PROTECT A. is supplied with its battery fully charged.
Nevertheless, energy may have been lost during transport, so
the battery should be fully recharged before it is used for the
first time.
Connect the input of the UPS (no. 2 in the figure in chapter 4.3
on page 19) to the mains connection cable provided and plug
the mains connector into a suitable shockproof socket. Allow
the UPS to charge up for about 6 hours without any load (i.e.
without any devices such as computers, monitors, etc.
connected to it).
i
5.4

Connecting the Load (e.g. computer)

Connect your loads to the individual UPS backed-up output
sockets on the rear of the UPS (chapter 4.3 / no. 1 / pg.19).
The battery is charged irrespective of the setting
of the main switch on the front of the UPS.
21
6 hours