Charging; Placement - AEG Protect alpha 450 User Manual

8

4.2. CHARGING

This unit is shipped from the factory with its internal battery fully charged,
however, some charge may be lost during shipping and the battery should be
recharged prior to use. Plug the unit into an appropriate power supply and
allow the UPS to charge fully by leaving it plugged in for at least 6 hours with
no load connected (i.e. no electrical devices such as computers, monitors, etc.).

4.3. PLACEMENT

Install the UPS unit in any protected environment that provides adequate
airflow around the unit, and is free from excessive dust, corrosive fumes and
conductive contaminants. Do not operate your UPS in an environment where
the ambient temperature or humidity is high.
Locate the UPS at least 20 cm away from the monitor to avoid interference.