Table of Contents
Advertisement
Installation
Remove all packing materials from the
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply. The device can be music-controlled by its built-in
microphone.
Control Modes
There are 5 Modes:
One Zipp LED (Automatic)
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
When the
Zipp LED
Dipswitch #8 must always be set to ON for Automatic control. Only use the
adjust the sensitivity.
One Zipp LED (Custom)
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
When the
Zipp LED
Dipswitch #8, #9 and #10 must always be set to OFF for custom control.
Light (8) control to adjust the sensitivity.
A
B
A. You can use Dipswitch
B.
You can use Dipswitch
a time. When #5, #6 and #7 are turned OFF, there is no strobe and the LEDs are on constantly.
#5 = Strobe Slow
#6 = Strobe Medium
#7 = Strobe Fast
Zipp
1) Automatic
2) Custom
3) Sound-controlled
4) Master/Slave
5) DMX512 (3 Channels)
is not connected by a DMX-cable, it functions as a stand-alone device.
Program 1
is not connected by a DMX-cable, it functions as a stand-alone device.
#1 (R), #2 (G), #3 (B) and #4 (W) to combine your custom colors.
#5, #6 or #7 to control the strobe speed. You can only select one dipswitch at
LED. Check that all foam and plastic padding is removed.
: Dipswitch #8 to ON
8
Motor Sensitivity (7) to
You can use the Motor (7) or
Advertisement
Table of Contents
