Door - Falcon Professional+ FXP 90 Dual Fuel User Manual

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
Fig.9-16
ArtNo.062-0001 - 90 Prof+ FX - Removing the door
Fig.9-17
ArtNo.325-0002 - BI oven removing the door
Fig.9-18
ArtNo.272-0015 - 90DF - Pro+ - Removing the outer door panel
Fig.9-19
(x2)
(x2)

5 Door

5.1. To Remove the Oven Door
CAUTION!
The door is very heavy. Take care when removing.
To remove the door, open the door fully.
Swivel the locking 'U' clips forward to the locking
position (Fig.9-16). Grip the sides of the door, lift
upwards and then slide the door forwards (Fig.9-17)
and remove.
5.2 To Remove the Outer Panel
Undo the 4 screws (2 each side) in the door (Fig.9-18).
Open the door slightly and, using the handle, lift the
door outer away.
To refit the door, first close the door inner. Lift the door
outer panel onto the door inner, – make sure the top of
the door outer panel fits over the locking mechanism
before locating the sides. Secure in position.
5.4 To Replace the Door Glass Panel
Remove the oven door (see 5.1).
To Remove the Inner Door Glass Panel
Carefully place the door, outer side up, on a clean
level surface. Undo the 3 retaining screws in the top
of the door and remove the trim. Undo the 5 retaining
screws from the lower edge of the door and remove the
bottom trim (Fig.9-19). Lift out the glass panel.
To Remove the Centre Glass
Carefully place the door, inner side up, on a clean level
surface. Remove the outer door panel (see 5.2).
Undo the 8 screws holding the centre glass panel
assembly in place (Fig.9-20). Lift out the centre glass
panel assembly, gasket and inner centre glass panel.
Reassemble in reverse order.
38