Moving The Cooker; Removing The Oven Door; Lowering The Two Rear Rollers; Completing The Move - Falcon Professional+ FX User's Manual & Installation Instructions

Check the appliance is electrically safe and gas sound when you have finished.
Fig. 9.3
ArtNo.062-0001 - 90 Prof+ FX - Removing the door
Fig. 9.4
Fig. 9.5
INSTALLATION

Moving the cooker

On no account try and move the cooker while it is
n
plugged into the electricity supply.
The cooker is very heavy, so take great care.
n
We recommend that two people manoeuvre the cooker.
Make sure that the floor covering is firmly fixed, or removed,
to prevent it being disturbed when moving the cooker
around.
To help you, there are two levelling rollers at the back, and
two screw-down levelling feet at the front.
Remove the polystyrene base pack. From the front, tilt
the cooker backwards and remove the front half of the
polystyrene base (Fig. 9.2). Repeat from the back and remove
the rear half of the polystyrene base.

Removing the oven door

To remove the oven door, open the door fully. Swivel the
locking 'U' clips forward to the locking position (Fig. 9.3). Grip
the sides of the door, lift upwards and then slide the door
forwards (Fig. 9.4).

Lowering the two rear rollers

To adjust the height of the rear of the cooker, first fit a 13 mm
spanner or socket wrench onto the hexagonal adjusting nut
(Fig. 9.5).
Rotate the nut – clockwise to raise – counter-clockwise to
lower. Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.

Completing the move

Unfold the rear edge of the pack base tray. Grip the fascia
panel and lift the front of the cooker slightly.
Carefully push the cooker backwards off the pack base.
Remove the pack base. Position the cooker close to its final
position, leaving just enough space to get behind it.
DO NOT use the control knobs to manoeuvre the
n
cooker.

Levelling

You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended position, taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker. To adjust the height of the rear of the cooker, turn the
adjusting nuts at the front bottom corners of the cooker. To
set the front feet turn the bases to raise or lower.
26