Konica Minolta bizhub PRO950 Troubleshooting Manual page 5

Recycle unit
The following parts number was established by service parts.
57GA-2303
[MIF machines : For the combination of bizhub PRO950 + RC-501]
Name
(New)Developing unit
(New)Recycle unit
RC mounting kit
Engine firmware
It is necessary to change DipSW. (For New developing unit) (DIPSW24-0 = bit01)
[MIF machines : bizhub PRO950 (RC-501 uninstallation)]
Name
Developing unit
Engine firmware
It is necessary to change DipSW. (For New developing unit) (DIPSW24-0 = bit01)
<Important information>
[When you mistake the combination by setting of the old /new type developing unit and
DipSW.]
The timing of the toner supply is different by new type and old type of the developing unit.
Therefore, it is necessary to match it to the DipSW setting suitable for the type of the
developing unit.
Switch DIP-SW for New
developing unit
Address
DipSW
24-0
24-0
Parts number & Firmware version
A0Y5R70311
57GA-2303
57GA-K011
Ver.20
Parts number & Firmware version
A0Y5R70311
Ver.20
Developing unit
New type
Bit
1(New) O
0(Old) X
Degree of incidence
Old type
X: The image density
X
decreases.
O X: Toner spill increases.
3/48