Error Messages And Fault Correction - CAB Eos Operator's Manual

30 8 Fault Correction

8.3 Error Messages and Fault Correction

Error message
Barcode too
big
Barcode
error
Buffer
overflow
Card full
Cutter
blocked
Device not
conn.
File not
found
Font not
found
Head open
Head too hot
Material too
thick
Memory
overflow
Cause
The barcode is too big for the
allocated area of the label
Invalid barcode content, e.g.
alphanumeric characters in a
numerical barcode
The input buffer memory is
full and the computer is still
transmitting data.
No more data can be stored
on the medium.
Cutter cannot return into its
home position and stays in
an undefined position
No cutter function
Programming addresses a
non-existent device
Requested file is not on the
data medium
Error with the selected
download font
Printhead not locked
Printhead is overheated
Material too thick or hard,
cutter does not cut through
material but can return to
initial position.
Blunt blades
Current print job contains
too much information, e.g.
selected font, large graphics
Remedy
Reduce the size of the barcode
or move it.
Correct the barcode content.
Use data transmission via
protocol (preferably RTS/CTS).
Replace medium.
Switch off the printer. Remove
material. Switch on the printer.
Restart print job.
Check material
Switch the printer off and then
on.
If error recurs call service.
Either connect this device or
correct the programming.
Check the contents of the data
medium.
Cancel current print job, change
font.
Lock printhead.
After pausing the print job will
be continued automatically.
If the fault recurs repeatedly,
reduce the heat level or the print
speed via software.
Cancel print job.
Check material.
Clean or change blades  7.5
on page 26
Cancel current print job.
Reduce amount of data to be
printed.
31 30