Operation Section; Lifting And Storage; Product Lifting - Perkins 1206F-E70TA Operation And Maintenance Manual

32

Operation Section

Product Lifting

Operation Section

Lifting and Storage

Product Lifting
NOTICE
Never bend the eyebolts and the brackets. Only load
the eyebolts and the brackets under tension. Remem-
ber that the capacity of an eyebolt is less as the angle
between the supporting members and the object be-
comes less than 90 degrees.
When it is necessary to remove a component at an
angle, only use a link bracket that is properly rated for
the weight.
Read all the information within produce lifting before
any lifting is attempted. Ensure that the correct set of
lifting eyes for the assembly to be lifted have been
selected.
Use a hoist to remove heavy components. Use an
adjustable lifting beam to lift the assembly. All
supporting members (chains and cables) should be
parallel to each other. The chains and cables should
be perpendicular to the top of the object that is being
lifted.
Engine and Clean Emission Module
(CEM)
i05350494
Illustration 30
Typical example
(1) Lifting eyes for engine and aftertreatment.
Refer to illustration 30 for the location of the lifting
eyes in order to lift the assembly.
CEM Only
Ensure that the exhaust inlet for the CEM is not
damaged during removal and installation. Do not
allow the weigh of the CEM to act on the exhaust
inlet.
SEBU8732
g03051657