Connections; Connecting The Antennas - JVC CA-UXQD9S Instructions Manual

Connections

Connecting the Antennas

Connecting the AM antenna
1
Set up the AM antenna (supplied).
2
Connect the antenna cord.
Main unit (rear view)
Connecting the antenna
cord
Connect the ends of
the antenna cord as
shown above.
3
Turn the AM loop antenna to find
the best position for radio
reception.
Place the AM loop antenna as far
from the main unit as possible.
• Do not place the AM loop antenna on a
metallic table or close to a TV, computer, or
other electric appliances. Doing so may
affect radio reception.
When positioning the antennas, find the best position for reception while listening to an actual radio program
(refer to "Listening to Radio Broadcasts" (
11
Connect all necessary parts before connecting the power plug.
Insert the tab into
the slot.
Main unit (side view)
When insulation
covers the tips of
the antenna cord,
twist and pull off
the insulation.
page 19)).
■When radio reception with the supplied AM
loop antenna is poor
Twist together vinyl-
covered wire and the AM
loop antenna cord.
Main unit (rear view)
Introduction
Vinyl-covered wire: 3 - 5 m
(not supplied)
Stretch out the vinyl-
covered wire horizontally,
preferably in a high place
such as above a window
or outdoors.
Connect the AM loop
antenna cord to the main
unit together with the
vinyl-covered wire.