Operating The Tv Using The Remote Control - JVC CA-UXQD9S Instructions Manual

This page is for when operating your TV using
the remote control of this product.
Operating the TV Using the
Remote Control
Setting the manufacturer's code
1
Slide the remote control mode
selector to the TV side.
2
Hold down .
NOTE
• Hold down until step 4 is completed.
3
Press and release.
4
Examples:
If there are two or more manufacturer's codes, try
them in turn and select the one that causes the
product to work properly.
Manufacturer
JVC
Hitachi
Remote control
Magnavox
mode selector
Mitsubishi
Panasonic
Philips
RCA
5
Number buttons
Operate the remote control by pointing it towards
the TV.
*1 Make sure to slide the remote control mode selector
Press number buttons (1-9, 0).
For a Hitachi TV: Press 1, then 0.
For a Toshiba TV: Press 0, then 8.
Code Manufacturer
01 Samsung
10 Sanyo
02 Sharp
03 Sony
04, 11 Toshiba
14 Zenith
05
Release .
NOTE
• The manufacturer's codes may be changed without
notice. You may not be able to operate a TV
produced by the manufacturer shown above.
For TV operation
Turn on/off the power.
Change channels.
Adjust volume.
- /
/
Change between the previously
selected channel and the cur-
rent channel.
Change between TV and video
input.
to the TV side in advance.
NOTE
• When the batteries are replaced, perform the
manufacturer's code setting again.
Code
12
13
06
07
08
09
Select channels.
*1
10