Connecting Power Over Ethernet - Cisco 860 Series Hardware Installation Manual

Connecting Power over Ethernet

Figure 3-23
1
Step 2 Connect the other end of the cable to the DSL wall jack.
The primary WAN port is designed for an RJ-45 connector only. Damage to the primary WAN port may
Caution
occur if a non RJ-45 connector is inserted
The DSL line must be provisioned by your service provider and correctly configured so that the LED
Note
shows the carrier detect (CD) status.
Connecting Power over Ethernet
Warning This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit. Statement 1028
This product must be connected to a power-over-ethernet (PoE) IEEE 802.3af compliant power source
Warning
or an IEC60950 compliant limited power source. Statement 353
Cisco 860 Series, Cisco 880 Series, and Cisco 890 Series Integrated Services Routers Hardware Installation Guide
3-24
Connecting the xDSL Line
1
2
G.SHDSL port, VDSL2oPOTs port, or
ADSL2+ port
Chapter 3
2
DSL wall jack
Connecting the Router
OL-16193-04