Power Over Ethernet; Front Panel Leds - Cisco Catalyst IR1800 Series Installation Manual

Product Overview

Power over Ethernet

A 30.8W capacity PoE PSE power supply is built into the IR1800. The power supply can power any of the LAN
switch ports that are compliant with PoE and PoE+ 802.3af and 802.3at Powered Device (PD) specification,
subject to 30.8 W maximum power shared among all ports.

Front Panel LEDs

The following figure shows the locations of the LEDs.
Table 5: LED Descriptions
LED Description
Number
1 Ignition Status
2 System Status
3 and 4 Digital I/O
5 GNSS Module
LED Status
Off: Ignition power management is disabled when SYS LED is on.
Steady Green combined with SYS LED Off: Ignition signal is off (power
management is enabled).
Steady Green combined with SYS LED On: Ignition signal is on.
Flashing Green with Ignition Off: Timer counts down when SYS LED is
on.
Steady Yellow: Ignition power management feature is not loaded.
Steady Green: Operational.
Flashing Green: Cisco IOS-XE booting.
Steady Yellow: System in ROMMON mode.
Off: No power.
Off: Inactive.
Steady Yellow: Active.
Steady Green: GNSS/DR configured; location fix achieved.
Flashing Green: GNSS DR active; trying to achieve location fix.
Off: GNSS DR not configured.
Cisco Catalyst IR1800 Rugged Series Router Hardware Installation Guide

Power over Ethernet

19