Cisco 860 Series Hardware Installation Manual page 20

Cisco 880 Series ISRs
2. Ports 0 and 1 provide PoE with the optional PoE module installed.
Caution
Figure 1-6
antennas on the back panel. However, the feature locations are similar across all Cisco 880 series data
routers.
Figure 1-6
1
ISDN port—not available on 3G models
2 Primary WAN port
VDSLoPOTS, ADSLoPOTS, ADSLoISDN,
or 10/100 FE
3
Antenna—captive omnidirectional dipole
WLAN antenna (wireless models only)
4 4-port 10/100 Ethernet switch
5 Serial port—console or auxiliary
1. The Cisco 880 series ISRs can include an optional PoE module that provides power to 802.3af-compliant devices connected
to ethernet ports 0 and 1. If this feature was not configured with the factory order, you must order and install it to enable the
PoE function.
2. Depending on the router model, the primary WAN port can be G.SHDSL, VDSLoPOTS, or 10/100 FE. The VDSLoPOTS
port is in the same location as the G.SHDSL port. The 10/100 FE WAN port is located at the bottom left corner. See
for the location of the 10/100 FE WAN port.
Cisco 860 Series, Cisco 880 Series, and Cisco 890 Series Integrated Services Routers Hardware Installation Guide
1-6
The primary WAN port is designed for an RJ-45 connector only. Damage to the primary WAN
port may occur if a non RJ-45 connector is inserted.
shows the back panel details of the Cisco 888W data router. Nonwireless routers do not have
Back Panel of the Cisco 888W Data Router
1 2
2
—G.SHDSL,
3 4 5
6
PoE power connector for optional PoE
1
module
7 Reset button
8
Power connector
9 Earth ground connection
10 Kensington security slot
Chapter 1 Product Overview
6 7 8 9 10
Figure 1-2
OL-16193-04