Cleaning Friction Studs - usi CSL2700 Owner's Manual

If film rolls begin to shudder or squeak, cleaning of tension assembly is required.
StEP 1:
remove the film rolls.
StEP 2:
remove the right side housing.
StEP 3:
disassemble the friction stud by unfastening
and removing the knob. Photo 23-1.
StEP 4:
remove the spring, metal washer, leather
washer and the friction stud. Photo 23-2.
StEP 5:
to clean, wipe the mounting hole free of excess
debris. Use rubbing alcohol. Photo 23-3.
StEP 6:
clean the friction stud groove and leather washer.
Use the Scotch Brite ® pad from the cleaning Kit.
StEP 7:
to reassemble, reverse the procedure as noted
above. reset the tension as on page 12.
23

clEanInG FrIctIon StUdS

Photo 23-1
Photo 23-2
Photo 23-3