Cleaning The Heat Shoe; Cleaning The Rubber Roller - usi CSL2700 Owner's Manual

Photo 15-2
Photo 15-3
15
clEanInG tHE HEat SHoES
With continuous use the heat shoes and rubber rollers may accu-
mulate adhesive and dirt. It is recommended that you periodically
inspect them for adhesive build-up. Use USI's laminator cleaning
Kit, which contains cleaning fluid, a coarse scrubbing pad and a
mesh covered sponge, for removal of any adhesive build up.
moisten the sponge pad with cleaning fluid and wipe down the
heat shoes.
notE: Be sure to clean the heat shoes only when the laminator is
cool.
caUtIon: teflon coated heat shoes are scratchable.
Periodically inspect the rubber laminating and pull rollers for adhe-
sive build-up.
remove the upper heat shoe to gain access to the laminating roll-
ers for cleaning.
clEanInG tHE rUBBEr rollErS
notE:
ished laminations, this may indicate that cleaning of the rollers is
necessary.
Before cleaning be sure the laminator is cool.
Use a dry Scotch Brite ® pad to remove excess adhesive from the
rollers. Photo 15-3.
turn the drive switch on and off to advance the rollers and clean
each section at a time.
Wipe clean with the sponge pad and cleaning solution from USI's
laminator cleaning Kit.
notE:
onto wiring or into "ends" of laminator.
WarnInG: do not use any sharp metallic objects or steel wool to
clean the rubber rollers.
Use of such abrasive objects can damage the rubber surface of the
rollers. USI strongly recommends the laminator cleaning Kit for all
of your cleaning needs.
If indentations begin to appear on the surface of fin-
Use cleaning solution sparingly. do not allow to "run"