Removing The Rubber Rollers - usi CSL2700 Owner's Manual

notE: only remove rollers if they are cut or in poor
condition.
notE: the following procedure removes all 4 rollers.
In certain instances, it is not necessary to remove all 4 rollers,
therefore, remove as required.
StEP 1:
remove all film from laminator. Photo 18-1.
StEP 2:
Unplug laminator. make sure it is cool.
StEP 3:
remove the thermometer and heat knob from the left side
of laminator. remove the side housing on both sides of the laminator.
StEP 4:
remove the top heat shoe. Photo 18-2.
refer to diagram and instructions on page 16.
StEP 5:
Unfasten and remove the pressure adjusting screws on
both sides of the laminator. Photos 18-3, 18-4.
Photo 18-3
StEP 6:
loosen the allen head set screws on the left and right ends
of the top rubber rollers. Photo 18-5.

rEmovInG tHE rUBBEr rollErS

Photo 18-4
Photo 18-1
Photo 18-2
Photo 18-5
18