Table of Contents
Advertisement
PrESSUrE
the pressure settings for the rubber rollers on USI laminators are preset at the factory and should not require adjusting.
In most cases, it is necessary to adjust pressure after the rollers have been removed for service. (Generally this is the
only time an adjustment is required.)
If an adjustment is necessary, disconnect electrical power and remove both the left and right
housings.
Photo 21-2
locate the Slotted Screw holding compression Spring.
Slotted Screw and compression Spring locations are
identical on both sides of the laminator. Photo 21-2.
Photo 21-3
to increase pressure, turn the flat head screw clockwise.
there should be 2-3 threads of the screw showing through
the bottom of the bracket. Photo 21-3.
WarnInG: It is extremely important that pressure
adjustments are always made exactly the same on both
sides of the laminator in order to maintain even pressure.
21
Hide quick links:
Advertisement
Table of Contents
