Cleaning Friction Studs - usi CSL2700 Owner's Manual

If film rolls begin to shudder or squeak, cleaning of tension assembly is required.
STEP 1:
remove the film rolls.
STEP 2:
remove the right side housing.
STEP 3:
dissemble the friction stud by unfastening
and removing the knob. Photo 23-1.
STEP 4:
remove the spring, metal washer, leather
washer and the friction stud. Photo 23-2.
STEP 5:
to clean, wipe the mounting hole free of excess
debris. Use rubbing alcohol. Photo 23-3.
STEP 6:
clean the friction stud groove and leather washer.
Use the Scotch Brite ® pad from the cleaning Kit.
STEP 7:
to reassemble, reverse the procedure as noted
above. reset the tension as on page 13.
23

clEanInG FrIctIon StUdS

Photo 23-1
Photo 23-2
Photo 23-3