Heat Settings - usi CSL2700 Owner's Manual

Prior to laminating, allow the machine to pre-heat at least 15 minutes in order to stabilize the
temperature. temperature settings depend on the film type being used. the temperature is preset at the factory, but
may require adjustment depending on what type of film you are using.
turn the heat on by depressing the heat power switch on the left side panel. the red indicator light will illuminate and
remain lit while the machine is in the "on" position.
after the machine has been heated for 15 minutes, adjust the heat knob located on the end of the machine, in the
side housing, to the desired temperature setting. allow the machine to heat for another 5 minutes in order to get an
accurate reading. check your thermometer to confirm your temperature setting.
11

HEat SEttInGS

Photo 11-1
tYPE
Standard
opti clear
Photo Plus
digiSeal
HEat ranGE
260-290°F
210-245°F
220-250°F
180-220°F