Cleaning The Rubber Rollers - usi ARL-PRO-2700 Owner's Manual

4.5 Heat Settings for ProMount Pressure Sensitive
Products...
We do not recommend using any heat with ProMount Pressure Sensitive Products.
5. Cleaning the Machine...
If you service the laminator yourself, call USI Technical Assistance (800-752-9131) for additional
service and safety recommendations.

5.1 Cleaning the Rubber Rollers

With continuous use, the Rubber Rollers will accumulate adhesive and dirt. If indentations or
bumps begin to appear on the surface of the finished lamination, or the Rubber Rollers have
"shiny" spots on them (especially on the ends), cleaning is necessary. Use a dry Scotch Brite®
scrubbing pad to cut through adhesive deposits. Rotate the Speed Control Knob to a slow speed
setting and toggle the Motor Drive Switch between the "FORWARD" and "OFF" positions to
advance the rollers and clean all areas. Proceed to wipe the rollers clean using the sponge pad
moistened with cleaning fluid.
Notes:
 Be certain that the laminator has cooled down to room temperature when cleaning the
Rubber Rollers to avoid the chance of burns.
 Use cleaning fluid sparingly; Do Not allow it to "run" onto wiring or into the "ends" of the
laminator.
 Do Not use knives, scissors, any sharp metallic objects or steel wool to clean the Rubber
Rollers. Use of such objects will damage the rubber surfaces and require replacement of
the rollers. Damage of this nature is not covered under the Manufacturer's Warranty.
For additional maintenance and service procedures call USI Technical Support for
recommendations.