Auto Standby - JVC CA-UXQ1S Instruction Manual

NOTE
• During operation, you can return to the previous
step by pressing . You can quit the playback
timer settings by pressing
not stored.
• When the playback timer starts, the volume grad-
ually increases to the selected level.
Canceling the playback timer
function
In step 2 on page 41, select the timer number you
want to cancel, and then press
Even when you cancel the playback timer, the set-
ting remains stored.

Auto Standby

If no sound is produced for 3 or more minutes
when a sound source other than the FM/AM radio
is selected, the main unit automatically turns off.
■When a sound source other than the FM/
AM radio is selected
Press .
"A. STANDBY" stands for "Auto Standby".
Auto standby indicator
Auto standby performance
While a CD, MD, or cassette tape is being
played back or recorded:
When playback or recording finishes, auto standby
starts the countdown (The "A.STANDBY" indicator
flashes). When no operation is carried out within 3
minutes, the main unit automatically turns off.
When you start playback or recording within 3 min-
utes, auto standby starts the countdown again
after playback or recording finishes.
. The settings are
.
Activating the playback timer again
In step 2 on page 41, select the timer number you
want to activate, and then press
until all of the setting procedure finishes. Then turn
off the main unit.
NOTE
• When you want to activate two or three playback
timers, leave a blank time of 2 or more minutes
between the ending time of the first playback timer
and the starting time of the second playback timer.
If the blank time is less than 2 minutes, the second
playback timer does not work.
• When the power plug is disconnected or the
power is cut, the playback timer settings may be
lost. If the settings are lost, set the clock and
playback timer again.
When an operation other than playback and
recording finishes and no operation is carried out
within 3 minutes, the main unit automatically turns
off.
While you are listening to sound from other
equipment
When no sound is produced, auto standby starts
the countdown (The "A.STANDBY" indicator
flashes). When no operation is carried out within 3
minutes, the main unit automatically turns off.
"A. STANDBY OFF" starts to flash 20 seconds
before the main unit is to turn off.
Canceling auto standby
Press once again.
NOTE
• Leaving the volume at "0" is not the same as pro-
ducing no sound, and therefore does not start the
auto standby function.
Introduction
repeatedly
42