2-4.2 Fsb Frequency Select (By Sw1 Dip5~Dip8) - SOLTEK SL-65LIV User Manual

2-4.2 FSB Frequency SELECT (By SW1 DIP5~DIP8)

• Over clocking is not recommended, your system may work unstable.
• SW1 DIP5~8 settings for FSB (Front Side Bus) Frequency Select is a
redundancy device designed for professional CPU overclocking only.
Since this mainboard is designed with CPU clock auto-detection function,
you are recommended to use the SW1 DIP5~8 default setting for a stable
system performance. In case of CPU overclocking to higher frequency,
these exists high possibility of failure due to the high complexity
of components adopted on board. On the other hand, selecting a lower
frequency setting for a CPU with higher frequency (e.g. select 100MHz
setting for a 133MHz CPU) will also cause system failure.
SW1 DIP5 ~ DIP8
66/100/133MHz
Auto Select
(default)
66MHz
100MHz
133MHz
21
Chapter 2 Hardware Setup
8 7 6 5 4 3 2 1
DIP
ON
8 7 6 5 4 3 2 1
DIP
ON
8 7 6 5 4 3 2 1
DIP
ON
8 7 6 5 4 3 2 1
DIP
ON