Removing The Steering Arm; Installing The Steering Arm - Yamaha F50F Service Manual

BRKT

Removing the steering arm

1. Remove the circlip 1.
2. Remove the steering yoke 2 by striking
it with a plastic hammer.
3. Remove the steering arm from the swivel
bracket assembly by pulling the arm off
the bracket.

Installing the steering arm

1. Install the washer 1, bushing 2, new O-
ring 3, and bushing 4 onto the steering
arm 5.
2. Place the swivel bracket 6 in an upright
position, and then install the steering arm
onto the swivel bracket assembly.
3. Install the bushing 7, new O-ring 8, and
bushing 9 onto the swivel bracket
assembly.
7-23
Bracket unit
4. Install the steering yoke 0 onto the
steering arm 5 by aligning the center a
of the yoke with the center b of the
steering arm.
5. Install the circlip A.
6. Inject grease into the grease nipple until
grease comes out from both the upper
and lower bushings c.
6C13G11