Assembling The Power Trim And Tilt Unit - Yamaha F50F Service Manual

BRKT
Assembling the power trim and tilt
unit
1. Hold the trim cylinder in a vise using alu-
minum plates on both sides.
2. Install the filters and gear pump assem-
bly 1 by installing the bolts 2, then tight-
ening them to the specified torque.
3. Install the manual valve 3 and reservoir
cap 4.
2
2
1
3
Gear pump bolt 2:
5 N·m (0.5 kgf·m, 3.7 ft·lb)
Reservoir cap 4:
7 N·m (0.7 kgf·m, 5.2 ft·lb)
4. Fill the reservoir with the recommended
fluid to the correct level as shown.
7-45
Bracket unit
4
S6C17740
Recommended power trim and tilt
fluid:
ATF Dexron II
5. Install the new O-ring, joint, and power
trim and tilt motor 5 by installing the
bolts, then tightening them to the speci-
fied torque.
PTT motor bolt:
4 N·m (0.4 kgf·m, 3.0 ft·lb)
6. Add fluid of the recommended type to the
first level at the bottom of the trim cylin-
der.
6C13G11