Assembling The Forward Gear; Assembling The Drive Shaft; Installing The Pinion - Yamaha F50F Service Manual

LOWR
3. Install the sleeve, original shim(s), and
taper roller bearing outer race.
CAUTION:
Add or remove shim(s), if necessary, if
replacing the taper roller bearing or lower
case.
NOTE:
• Apply gear oil to the inside and outside of
the sleeve before installation.
• Install the sleeve with the projection e fac-
ing forward.
Bearing outer race attachment 6:
90890-06627
Driver rod LS 7: 90890-06606
4. Install the original shim(s) and taper roller
bearing outer race.
6-17
Lower unit
CAUTION:
Add or remove shim(s), if necessary, if
replacing the taper roller bearing or lower
case.
Bearing outer race attachment 8:
90890-06622
Driver rod LL 9: 90890-06605

Assembling the forward gear

1. Install a new taper roller bearing into the
forward gear using a press.
Bearing inner race attachment 1:
90890-06639

Assembling the drive shaft

1. Install a new drive shaft bearing onto the
drive shaft using a press.
Bearing inner race attachment 1:
90890-06644

Installing the pinion

1. Install the forward gear, then the drive
shaft assembly, pinion, and pinion nut,
and then tighten the nut to the specified
torque.
6C13G11