Replace; Fuel System Secondary Filter - Replace - Perkins XGA 1600 Series Operation And Maintenance Manual

80
Maintenance Section

Fuel System Secondary Filter - Replace

3. Ensure that the assembly is clean and free from
dirt. Remove the element (6) from cap (2). Ensure
that the element housing is clean and free from
dirt. If dirt remains within the housing, the fuel line
(5) must be removed, in order to allow cleaning
of the housing.
Illustration 57
Typical example
4. Inspect the element, if the element is damaged,
replace the element.
5. Align the element to the cap and push together.
Install cap and element assembly into filter body
and tighten to 18 N·m (13 lb ft). Turn the fuel inline
supply tap to the ON position
Fuel System Secondary Filter -

Replace

g02791860
Illustration 58
Typical example
1. Place a suitable container under the water
separator in order to catch any fluid that might
spill. Clean up any spilled fluid. Ensure that the
outer body of the filter assembly is clean and free
from dirt.
2. Install a suitable tube onto drain valve (4). Loosen
the cap (1) in order to allow atmospheric pressure
to act upon the fuel. Rotate the cap three and a
half turns in order to allow the vent hole to be
accessed. Open the drain valve (4) and allow the
fluid to drain.
3. After the fluid has drained, Close the drain valve
and remove the tube. Remove cap from filter body
(3). Removing the cap will also remove the filter
element (2). Remove filter element from the cap.
Remove the O ring seal (5) from the cap. Use
the cutout (A) in order to remove the O ring seal.
Discard the O ring seal and the filter element.
4. Ensure that the cap, and the inner of the filter
housing are clean and free from dirt.
5. Install new O ring seal to cap. Align new filter
element to cap and push together. Lubricate the O
ring seal and the threads on the cap with clean fuel
and install the cap assembly into the filter housing.
SEBU8455
i04654710
g02792418