System Controller Wv-Cu950 Setup - Panasonic WV-ASC970 Operating Instructions Manual

Note:
• "analog camera" stands for Panasonic analog cameras.
• "DVR" stands for Panasonic Digital Disk Recorder / Network Disk Recorder.
• In the redundant system, set both Main and Backup WV-ASC970 Servers' IP Addresses to the alarm notification
destination IP Address field of the network device.
• The Capacity Warning, RAID Down and Thermal are also included in DVR Error. For example, if both Capacity
Warning and DVR Error are assigned to different alarms and then the Capacity Warning occurs, both alarms are
triggered.
● System Controller WV-CU950 Setup
To add system controllers to the system in Ethernet communication, add an entry to the system controller database
through the admin console. You need to assign a controller ID for each controller, and enter the Ethernet address
from the bottom of each controller.
Note:
• Refer to the Admin Console User's Guide for details.
The MODE and CONTROLLER No. on WV-CU950 rear panel should be set as shown below.
MODE
WV-CU Set as shown below.
950
OFF
ON
1 2 3
MODE
CONTROLLER No.
Maintain the switch
setting as "1".
4 5 6 7 8
29