Enter Cameras/Encoders And Decoders In The Wv-Asc970 Admin Console; Sx650 Switch Node; Sx650 Switch Node And Its Domain; Enter Sx650 Subnodes In The Wv-Asc970 Admin Console - Panasonic WV-ASC970 Operating Instructions Manual

● Enter Cameras/Encoders and Decoders in the WV-ASC970 Admin Console
After deciding the Unit ID for each encoder and decoder, the next step is to enter the encoder and decoder device
information in the WV-ASC970 Admin Console for the domain.
In the WV-ASC970 Admin Console main menu and selecting IP DEVICES screen, we need to configure the devices
here.
Since these devices are part of the IP switch node, select IP from the Switch Nodes command on the Domain
menu.
● SX650 Switch Node
SX650 switch node consists of one more WJ-SX650 matrix switcher with WJ-PB65E01 network board. SX650
switch node can only be located within a system domain, and cannot cross over multiple domains. Currently, the
system only supports up to one SX650 switch node in a single system domain, and node ID is always set to its
domain ID by the system software.
● SX650 Switch Node and its Domain
In case of a single domain system, all the WJ-SX650 matrix switcher with WJ-PB65E01 network board will be
assigned to that domain.
In case of a multiple domain system, the system designer has to decide which domain all the WJ-SX650 matrix
switcher with WJ-PB65E01 network board should belong to.
● Enter SX650 SUBNODES in the WV-ASC970 Admin Console
After deciding the domain ID for each WJ-SX650 matrix switcher, the next step is to enter the information in the
WV-ASC970 Admin Console for the domain.
In the WV-ASC970 Admin Console, SX650 SUBNODES screen, we need to configure the devices. Since these
devices are part of the SX650 node, select SX650 from the Switch Nodes command on the Domain menu.
Following are the sample data for WJ-SX650 matrix switcher.
SWITCH
Address [MODE]
ID I/F IPA BRIDGE CONTROL OSD ALARM EA
Input Output
5 6 7 8
1 1 192.168.200.1 – 1 - 256 1 - 32 1 - 256 1 - 32 – OFF OFF OFF ON 00.00.00.00.00.00
■ How to Identify a Video Switch Link
● Links between a WJ-SX650 Switch Node and an IP switch node
In order to pass video from one switch node to another, video links are required. Page 20 shows an example of a
system with video links. In general, you can find video links in the following conditions:
• From a matrix switch output to a video encoder device.
The above video links can connect two video switch nodes within the same system domain or different system
domains.
26