Group Preset; Local Monitor Seize And Execute; Group Sequences; Local Monitor Seize - Panasonic WV-ASC970 Operating Instructions Manual

Note:
• To select a local tour sequence, just enter the logical tour sequence number. (Refer to p. 45.)
• The system supports up to 256 tour sequences running.
• During 3 seconds dwell time in case of WJ-GXD400, the video and OSD display will delay according to switch-
ing channel numbers.
■ Group Preset
● Local Monitor Seize and execute
The system allows operators to execute a group preset in only local domains. Before starting a group preset start, a
local monitor must be seized. Be sure that the group preset monitors are not seized by operators with higher priori-
ty.
■ Group Sequences
● Local Monitor Seize
The system allows operators to start and control a group sequence in only local domains. Before starting a group
sequence operation, a local monitor must be seized. Be sure that the group sequence monitors are not seized by
operators with higher priority.
● Group Sequence Operation
Group Sequence operations include start, stop, pause, run, next step, and previous step. (Refer to p. 45.)
● Group Sequence Priority
If another operator with higher priority has seized a Group Sequence monitor, that monitor will maintain the original
operator priority.
Note:
• Group Sequence monitors should be the same in each step of sequence and less than 33.
• During 3 seconds dwell time in case of WJ-GXD400, the video and OSD display will delay according to switch-
ing channel numbers.
• Group Sequence is not restored after reboot or switchover.
• When an operator select one of running group sequence monitor that is seized by other operator with same pri-
ority, the sequence keeps running.
When a operator seized one of running group sequence monitor that is not seized by the other operator with
same priority, the sequence stops.
11