Conversion Kit Instructions - kozy heat Chaska CSK-31 Installation Manual

CONVERSION KIT INSTRUCTIONS

#NCK-CSKMV-S NAT GAS CONVERSION KIT / #LCK-CSKMV-S LP GAS CONVERSION KIT
This conversion kit shall be installed by a qualified service agency in accordance
with the manufacturers instructions and all applicable codes and requirements of
the authority having jurisdiction. If the information in these instructions is not
followed exactly, a fire, explosion or productions of carbon monoxide may result,
causing property damage, personal injury or loss of life. The qualified service agency
WARNING
is responsible for proper installation of this kit. The installation is not proper and
complete until operation of the converted appliance is checked as specified in the
manufacturer's instructions supplied with the kit. Refer to appliance owner's
manual or product data plate for proper inlet and manifold pressure adjustments
and orifice sizing.
THE CONVERSION SHALL BE CARRIED OUT BY A MANUFACTURER'S AUTHORIZED REPRESENTATIVE, IN
ACCORDANCE WITH THE REQUIREMENTS OF THE MANUFACTURER, PROVINCIAL OR TERRRITORIAL
IMPORTANT
AUTHORITIES HAVING JURISDICTION AND IN ACCORDANCE WITH THE REQUIREMENTS OF THE
CAN/CGA-B149.1 OR CAN/CGA-B149.2 INSTALLATION CODES.
Kit includes:
(1) Burner Orifice: NAT #37 / LP #52
(1) Valve and Pilot Assembly Conversion Instructions
CAUTION
THE GAS SUPPLY SHALL BE SHUT OFF PRIOR TO DISCONNECTING THE ELECTRICAL POWER, BEFORE PROCEEDING WITH
THE CONVERSION.
SHUT OFF GAS SUPPLY AND ELECTRIC POWER TO FIREPLACE.
SHUT OFF GAS SUPPLY BEFORE DISCONNECTING ELECTRIC POWER.
WARNING
For high altitude installations: Above 2000ft. (610m) US / 4500ft. (1372m) Canada, consult the local gas distributor or
IMPORTANT
authority having jurisdiction for proper de-rating methods.
PREPARE THE FIREPLACE:
1. Turn fireplace off by pushing in and turning gas control knob clockwise to OFF position.
2. Remove glass frame assembly, logs, and burner assembly from fireplace insert.
REPLACE BURNER ORIFICES:
Remove existing orifice caps. Install orifice caps included with kit. Tighten caps securely.
NAT #37 / LP #52 (Number stamped on burner orifice).
Figure 16b
CONVERT THE PILOT ASSEMBLY:
1. Using a 7/16" wrench, loosen and remove pilot hood by turning counter-clockwise.
2. Remove pilot orifice located inside pilot housing. Install pilot orifice included with kit. (Number stamped on orifice).
NAT: BL22N / LP: #BL14LP
3. Re-attach pilot hood. Tighten with wrench, making sure hood is centered between thermopile and thermocouple.
(1) Pilot Injector: NAT #BL22N / LP #BL14LP
(1) Gas Conversion Label
PILOT ORIFICES
NAT LP
16
(1) Gas Label
Pilot Assembly
Burner Orifice
Figure 16a